BIGTREETECH TMC5160T Pro Stepper Motor Driver, Supports up to 56V, High Speed Print SPI & SD Modes with Heatsink Manta M8P/M5P/M4P, Octopus Pro Octopus SKR 3 EZ Control Board (4pcs)

Works great! I am using these for the XY motion system on (2) Octopus Pro and (1) Manta M8P V2. They work great. I just use the 2209’s for Z because I don’t see the need for 5160’s on Z.

This TMC5160T supposed to be handle big current high voltage. But Just put in 36V is enough to kill it with a mere load current 0.9A. Turn out it is worst than the 1s generation TMC5160 V1. The design on heat dissipation is the worst solution I have ever seen in my life. Heat sink is glue on with a tooth brush like material and can come off without notice. Apparently the main reason to kill this TMC5160T is the heat. I am not sure why the designer make the circuit board that is hard to put on a decent heat sink properly not to mention the advertisement said it suppose to handle up to 70V. Nope 24 V is the most it can do and we don't need it for the 24V application because plenty of orther TMC can work fine @ 24V. 1 star for the abd product can do nothing but died.

Installed drivers into a Manta 8b and it bricked the board. Returning all BTT products

Exactly as the title says, the SPI mode just doesn't work. I've tried them with multiple mainboards, still no connection.

Be aware that while this listing states V1.0 drivers you will actually receive V1.1 drivers which i had 2 already pop.