2FT LED RETROFIT KIT

Easy to install worked great to replace fluorescent bulbs inside fixture

Used this to repair my sunken light. Replacing it would be impossible because its sunk into the sheetrock.. I would have had to replace the ballast . The magnets are what you need just stick it in and wire it. Be sure to disconnect existing ballast. This is the second one i have done and its much les noisy than the old florescent lights.

These are a nice upgrade. I am asking a lot from these lights as well. These are currently installed on my Sand Blaster Cabinet. Like I said I ask a lot from them in a harsh environment. These lights provide way more light than the previous lights that came with the unit. The best par is they are LED. Better light color and quality. Will last way longer. Not sure what you may need but they are great lights, easy to install and have stood up to a very harsh environment for me.

i used the 2 foot long version to replace some old fluorescent under cabinet kitchen lights. I didn't want to replace the fixtures as they were integrated with the cabinets. The fixtures were 4 different lengths. i used 2 of the double LEDs and 2 of the single LEDs. Easy to install and i removed all of the fluorescent electronics. No more ballast hum! they work great. i had many questions and i received answers within 24 hours. i did not use a dimmer as this would require running a control wire. Product is very good!

Product appears to perform as advertised. Magnetic mounts on both light strips and the driver make it a snap to mount components where you want them instantly, and move them if you must. A convenient connector permits easy removal and reconnection of the driver. Light strips get warm, but not hot, to the touch. Driver warms very little. No worries about overheating. Build quality appears very good. Kudos to the designers who made all of this possible at an inexpensive price point. Dimming performance with 0-10V control is smooth and quiet, but limited in range. After dimming to somewhere around 20% of full brightness, lights suddenly turn off completely. As expected, the product is not compatible with standard triac based dimmers. Connecting one produced some audible noise even when set to maximum brightness. Attempts to dim further produced pronounced flickering at higher settings, and flashing at lower settings. Update: Responsiv Blink'n'Dim Adapter for 0-10V dimmable fixtures works well with this product. Unlike most 0-10V dimmers, it does not require you to run low voltage control wires between the fixture and dimmer switch. ASIN is B07H3FDQCT.

I have installed a number of these LED lighting strip systems throughout my house and they are great! This time I installed them in a dark hallway in my basement. I clipped the 2/2” light strips onto the metal lattice of a drop ceiling system with the attached, powerful, magnets. The strips throw a phenomenal amount of light. The wiring is relatively simple and could probably be done with 2 lead extension cord or zip wire. (Always follow your local wiring codes!) I highly recommend these retrofit kits!

works perfect. you do need zip ties to tidy up the wiring so that you don't have shadows inside the fixture, just position where you want and the magnets do the rest. excellent fix for old fixtures.

Easy to install.

Easy to install, and works well. 5000K is a little bright, so I will be installing dimmer switches.

Saw a few video’s suggesting these types of lights inside the HF or Princess Auto Cabinet. The factory light was impossibly dim. These lights are sealed and covered and super bright. The magnetic bases work perfectly for holding the light and ballast in place. Would recommend. Note: I need to replace my glass protector, it’s far brighter than the photo looks. All the lights in the shop were on, before I couldn’t see inside with the shop lights on.

Did exactly what it needed to do and was super easy to install.

excellent