12 Inch 80T Carbide Circular Saw Blade, Fine Finish Saw Blade (DWA11280)

Great cut quality , holds its edge real well. Great finishing blade.😄😄

Use this blade on my Dewalt DW780 sliding miter saw for trim work. Runs true, no vibration or singing, and nice fine cuts. Thin kerf works well too. Only completed about half the trim on a house so can't comment on longevity but still cutting great.

Great cutting blade for cedar and hard woods.

Still using the blade that the saw came with? Cuts looking a little frilly around the edges? Don't trust anything other than black and yellow? Then this is for you! Replacement blade for that 12 inch miter saw. Now you can cut things other than box store 2x4's and be proud of the finish. Easy to install - sure. If you are using the saw and still have all of your fingers then you can manage it just fine. Cutting speed - a little slower than a 40T but that goes with all of the extra teeth. Sharpness - fine, better than the one you're replacing.

Great replacement for my saw would purchase again worked very well

It was ok. Not great

Cuts very well. Purchased to cut pre finished ship lap. Works perfectly.

Works as expected.

Hubby just started using this yesterday. Blade life yet to be determined, as it was used for only a few hours cutting 1/2" MDF baseboard trim, but so far, it's doing a great job. Will update review if blade life isn't very good or if there are issues. For $59, this is a good purchase. Hubby loves his new Dewalt 779 compound mitre saw, as well. With this blade. they are a great combo!

parfais

Good quality saw blade at a competitive price and you don’t have to leave home to get one.

I installed this on my Bosch Mitre Saw and it works awesome.... It cut hardwoods like butter... I am buying another one just to have it in reserve...5 stars!!!!

Almost the smoothest cut I have ever had of any blade over the years in both hard and soft wood but a massive issue that has forced me to return not one but two of these blades is the ringing screaming sound these blades make once they reach full RPM and before you start cutting. I’m running this blade on a 12 in.² Delta radial arm saw, The harmonic ringing is so bad I had a next-door neighbor banging on my door only five minutes after turning the saw on wanting to know what in the heck was going on in the garage as he could hear it in his house with his music playing suffice to say blade went back thinking it was defective, second blade rang and screamed even more.. even tried some forest blade stiffening plats and they made no difference…. Teeth are exceptionally sharp it must be the geometry that is CUTTING the air causing the blade harmonics and ringing. Even tried on my Dewalt 12” miter saw and had the same screaming sounds… Your mileage may vary..