Micro Grip

These are extremely useful and they do stick pretty well. The only thing I would add as an improvement would be that the tape be a little thicker so that it will fit the contour of the helmet and adhere over the entire grip. I have had to replace the tape on several older helmets and I use a thicker tape.

Just used the micro grip during 10 days of skiing. They stayed attached to my helmet and kept my goggles from falling to the back of my helmet. As noted in other reviews, follow the instructions for attaching the grips. 1. clean the surface with included wipe 2. Attach the grips to the helmet and press with your thumbs to be sure they adhere 3. allow 24 hours to fully dry and attach and my suggestion is: during that time every 3 hours of so, hold the grip to a light to see if there is any daylight between the grip and the helmet, if there is, apply thumb pressure for a minute to the grip again. I had to do this several times as areas of the adhesion pulled away from the helmet a little bit. After 24 hours, the grip was fully attached and worked very well and, even at $20 I was happy with the way they worked.

They didn't work with my standard ski goggles. I tried several different pair of goggles, they didn't fit any of them. Don't buy these for ski goggles on a ski helmet. You'll waste your money.

Works as they should

I had one spot behind the ears on my helmet where there was just enough flat spot for these fit. I put them there and they stuck well. With these on I can easily flip my goggles up on my forehead with them flying back and getting tangled.I'd give it five stars except $16 ($13 something on Amazon) list price is more then two little plastics should really cost. But, I still think they were worth it. If these were $8.95, I'd give them five stars.

Good product, but for a larger helmet like a construction hard hat or fire helmet, you really need three clips. One on each side and one on the rear to keep the rear strap from riding up on top of the helmet. These clips also seem to work better on wide goggle bands (think ski goggles) as opposed to the typical 3/4' or 1" bands found on industrial safety goggles. As I have two helmets to outfit, I am buying one more set of 2 clips as I used 3 on the first helmet I set up and only have one left.

Works on ski helmet

These work perfectly to hold my goggles on my helmet, i recommend!